014-1066-050 - Follower plate for industrial pumps with shank 50 mm subgroup-Accessoires en losse onderdelen-Vet oplossingen Rigid polyethylene tank for diesel

Rigid polyethylene tank for diesel transport for non-commercial use eccept for ADR 1

To optimize the performance and the time-life of the air-operated pumps advise to use filtered and lubricated air

Inlet : F1/4"G

5 bar and a maximum of 8 bar

The operating pressure of the pumps can vary between a minimum of 3 bar and a maximum of 8 bar

014-1066-050 - Follower plate for industrial pumps with shank 50 mm subgroup-Accessoires en losse onderdelen-Vet oplossingen Rigid polyethylene tank for dieselIt is advisable to use always the follower plate. it is very important of ambient temperature is low and when high viscosity grease is used. Because of the depression created by the pump. the plate is attracted towards the bottom of the drum by atmospheric pressure. It pushing the grease into the pump and avoids air cavities. Also it removes the grease remaining on the walls down to the bottom of the drums.